List of performed works
1. Design of measuring installation to study the influence of structural defects, composition and state of primary converter material of noise thermometer, mechanical tensions in the primary converter on a level and spectral composition of noise voltage measured.
Technical characteristics:
- Average time, s — 1, 10, 100, 1000
- Relative measurement error, % (tu=1000 s) — 0.05
- Frequency range of noise voltage, kHz — 0–250
- Nominal value of the resistance of the test sample, Ohm — 1000
- ADC resolution, bits — 16
- Maximum discretization frequency of ADC, MHz — 2
- Gain of the correlation amplifier — 100,1000
- Data transmission interface — USB2.0
2.Design of the flowmeter to measure the volumetric flow of oil in telemetry divisions of pipeline. The flowmeter has explosion proof marking 1ExibIIBT3 X and meets the requirements of GOST 22782.5 and GOST 22782.0. It can be installed in explosive zones of premises and outdoor locations. The flowmeter can be used to control technological processes in metallurgical, chemical and other industries; in water supply and drainage systems or during the flow determination of water, acids, alkalis, oil, and petroleum refinery products, and other liquids.
Technical characteristics:
- Pipeline internal diameter, mm — 250; 325; 400; 500; 500; 700; 1000; 1200
- Pipeline wall thickness, mm — 9.5–17
- Flow velocity in the product pipeline, m/s — 0.25–9
- Relative error of flow measurement, % — 2
- Oil temperature in the pipeline, °C — 0–+30
Volume accounting is carried out considering the flow direction.